Step 7: Your First Drill
Time estimate: 15 minutes
What You'll Do
Return to the main menu, select a drill from the list, and load it onto the table. Your ICATS is fully configured at this point -- this final step is about getting familiar with the interface and starting your first training session.
Before You Start
- System update is complete and drill content is downloaded (Step 6)
- Table size is set correctly (Step 6)
- Calibration is confirmed (Step 5)
Load a Drill
Via EZUI
- Return to the main screen
In the EZUI on your phone or tablet, tap "Back" as needed until you reach the main drill list.
- Browse the drill list
The list shows all drills available on your system. You can filter by category or module using the filter controls at the top. The ICA Starter Module and Gnarly 90 content downloaded during the update are included here, along with the third-party sampler content.
- Open a drill
Tap a drill name to select it, then tap "Open." The drill image will appear on your table surface.
Via On-Screen Menu (keyboard)
Right-click in the center of the table and select a drill from the file list that appears. The drill loads immediately onto the table.
Getting Started with Drills
Each drill projects a layout directly onto your table -- target zones, ball positions, and reference lines that guide your shot and show where the cue ball should land. The EZUI controls which drill is active and lets you step forward and backward through a sequence.
Take a few minutes with the Starter Module first. It is designed as a broad introduction and covers a range of skill types. The Gnarly 90 is more challenging -- a set of 90 runout drills suitable once you are comfortable with the interface.
Additional drill modules covering a full spectrum of skills and skill levels are available at icatraining.com/shop. Tutorial videos at icatraining.com/tutorials demonstrate how to get the most out of each feature.
Where to Go From Here
Your ICATS is fully installed and running. A few resources worth bookmarking:
- ICATS Pro Users Guide -- covers the full feature set, including drill authoring and advanced settings
- EZUI Guide -- detailed reference for the phone/tablet interface (applies to both Pro and EZ)
- Support hub -- the first place to check when a question comes up
- icatraining.com/tutorials -- video walkthroughs of core features
Troubleshooting
Common Issues
Drill list is empty after the update Return to Settings and run the update again. If the list remains empty after a second successful update, contact support.
Drill image does not align with the table First confirm the table size setting is correct (Step 6). If the size is correct and images are still noticeably off, re-run calibration from Step 5. Small alignment errors after calibration are normal near the rail closest to the projector.
EZUI is not showing the drill list Tap "Back" from the Settings or Calibration screen. If the EZUI is unresponsive, close and reopen the browser on your phone and reload the URL shown on the table.
Setup Complete
Your ICA Training System is installed, calibrated, updated, and ready for training. Work through the included content at your own pace -- and when you are ready to go deeper, the Users Guide and EZUI Guide cover everything the system can do.